DI-1100 building a 3 phase amperage logger
I work with CNC stuff a lot and sometimes troubleshooting would be easier if I could see what is happening on 3-4 different power cables at the same time. So I've been running down a rabbit hole and came to the DI-1100 as a possible solution. My current
D-2108 locks up
Hello - I am very new to this, but am trying to setup a simple IR sensor with a D-2108 data logger, essentially as described here:jove-protocol-53377-a-simple-flight-mill-for-the-study-of-tethered-flight-in-insects We have built the breadboard as indicated
Device for analog measurement of 24vdc
What starter device can I use to monitor the 24vdc power supply voltage. I want to see any dips or sags over time. It does not have to be high speed. A sample every second is fine.
Power supply
I have a sensor that requires 15-30 VDC to power. Can I do this using the model DI-1100? And if not, what do I need?
Odd behavior using CPM and counter input on DI-155
I had a DI-155 handy and hooked the count input to a Geiger Counter output. I set the channel setting to CPM. Its not doing this correctly. It does not seem to be using a minute avg. If there are 3 counts super quickly together the count jumps way up. But if those counts are spaced by a few seconds each the count is way lower even tho they are during the same minute period. If you give it 1 count per minute, it does not display this. The 1 count stays there for like 3 seconds and then goes back to
running an obsolete instrument DI-148U with WIN10
Is it possible to run an obsolete Dataq instrument - DI-148U - with WIN 10? If not, what is my best option?